Straw removal in matted row strawberries – Facts for Fancy Fruit

Straw removal in matted row strawberries

The proper time to remove straw from matted row strawberries is when the bare-soil temperature at 4 inches averages about 40-43˚F. This usually coincides with mid to late March in central Indiana. This year is about average with most parts of central and northern Indiana at 40˚F or above as of 3/22/20. Plants begin pushing new leaves as the soil temperatures rise steadily so the straw should be raked off the tops of the beds and into the row middles before leaves emerge. Leaving some straw on top of the beds for plants to grow up through provides a clean surface for fruit. Straw should be removed from beds before the plants grow enough to cause yellowing of foliage. Allowing the leaves to become etiolated (yellowed with long petioles) due to late straw removal can reduce yields by as much as 25%. However, uncovering the plants early may promote early growth and increase chances of frost or freeze injury. The difference between early removal and late removal may increased first harvest by about three days, so there is no real advantage. After the straw is removed the frost protection irrigation equipment should be set up and tested and made ready for frost during bloom.

 

strawberry leaves

New leaves emerging in strawberries

Share This Article
It is the policy of the Purdue University that all persons have equal opportunity and access to its educational programs, services, activities, and facilities without regard to race, religion, color, sex, age, national origin or ancestry, marital status, parental status, sexual orientation, disability or status as a veteran. Purdue is an Affirmative Action Institution. This material may be available in alternative formats. 1-888-EXT-INFO Disclaimer: Reference to products in this publication is not intended to be an endorsement to the exclusion of others which may have similar uses. Any person using products listed in this publication assumes full responsibility for their use in accordance with current directions of the manufacturer.